Fill a Pistol Mag?

[Nark]

[ogrejager]

1. I'm in for cougar trollin' at the Cheese. Are those places even still open?

2. I don't underestimate the small people. My estimation of them is accurate. It's a low one, but it's an accurate one.

3. By the time I was 13, I was carrying a RS pistol on camping trips. So, yeah, it does happen.

[Nark]

Yah, actually there's a Chuckie Cheese's over on 90th and Powell. Might get some haggard cougars but there could be some diamonds in the rough... figuratively and literally.

We don't underestimate little people. We "underestimate" young people but they always prove us right when one of them shoots a teammate in the hand on full auto when we're in the prep room with mags out ..... *cough cough* cadpat *cough cough*

[ClownBaby]

We all make mistakes, let's move on.

As far as the hunting party go's, Chucky Cheese sucks now, it's all sterile, too well lit, and has NO VIOLENT VIDEO GAMES!!! WTF!

Dave and Busters is where it's at. Except they ALWAYS have at least two armed guards on duty. Which after meeting them during a job interview, I'm positive that they, upon seeing a group of men entering the building in camouflage, they would DEFINITELY set up a crossfire on us.

[Nark]

You mean I have nowhere to show off my proper firing stance with the shooting games anymore? There's always Wunderland. The douchebaggery at Dave and Busters is so over the top though.

[T-Time]

Well this topic sure got out of hand.

[Nark]

[Blackhawk]

[T-Time]

[Nark]

[Steve]

[Rentax]

I have heard that it is possible tor the o ring on the fill valve can get freez up and shrink a bit allowing it to leak gas. As it warms back up it expands and starts working again. This is usually cause my from a misalignment when filling.

Steve the TM brand MK23 mags have an over fill valve. Don't worry tho, it doesn't work properly, and when the mags warm up it blows open and then gets stuck in the open position. Repaing themis a pain in the a$$, and probably why you don't see over fill valves too often

[Steve]

That explains why I have 3 (of 3) bad TM mags, but all 5 of my "off-brand" mags for my NBB TM Mk.23 are running just fine. I didn't even think to look for an overpressure relief on them, just assumed that the welds were bad.

Thank you.

[Rentax]

Nope, it's a pain in the a$$ to fix, but worth it.
Pop the 2 pins from the bottom. And dremmel out a small nub. Remove the bottom. You'll see the hidden valve with a spring on it. I've heard, you lust remove the spring and in weld the lid closed. Once dry you reseal the mag and slip the two pins back in. I've got about 9 mags I need to do this on, But have so many y&p mags I just have never gotten around to it.

[Vernichtung]