Any experience with Matrix 40mm CNC grenade shells?

[Reeko]

Cant find any reviews of these things other than the manufacturers overviews. Which are pretty unreliable, since they will say anything to sell them. I was just wondering if anyone has experience with them. More specifically this one.

http://www.evike.com/product_info.php?c ... s_id=38165

And how it might compare to the Madbull multipurpose CO2 shells. I love the madbulls but paying 80 bucks a pop seems unreasonable if a 30 dollar shell does the job just as well, or at least close.

Please dont reply unless you can actually help. i dont need a giant off topic thread of personal opinions on the effectiveness of 40mm grenades. Just keep it simple guys. If the thread dies because nobody can help, than so be it.

[Payback]

Ask blue about them, i believe he has a few of them. If i recall, he said they weren't that great compared to the madbull ones, cause i asked him about them a few months back.

[timmah]

I had the "short" version for a little while. They seemed to function as well as the Madbull shells, with about half the power of course (owing to the half the size of the Madbull) I would buy them again, if I was looking to get more multi-use shells

[Jewish Ninja]

From my experince with MB, KA, POM and some other off brand shells, nothing beats MB shells. I'd look for used one since their retail price is nuts.

[Reaver]

If the above mentioned doesn't work, swap the piston head o-ring to a #14 from home depot, and there is also a modification that can be done to the mech box casing where the tappet plate comes to rest at the very front, basically removing a small amount of metal to allow the tappet plate/air nozzle to push a little farther into the hop up unit.

[Deleteplz]

I've had good luck with Dboys brand shells.

Normally "Matrix" brand stuff from evike is rebrands from CYMA, Dboys, A&K, etc.

[Reeko]

If the above mentioned doesn't work, swap the piston head o-ring to a #14 from home depot, and there is also a modification that can be done to the mech box casing where the tappet plate comes to rest at the very front, basically removing a small amount of metal to allow the tappet plate/air nozzle to push a little farther into the hop up unit.

wrong thread bro. lol

[Reeko]

thanks guys