Gearbox "exploded"

[thefiestysoldier]

So i just wanted to simply switch out a spring on my jg g36. when i tried to pop open my box it exploded and the parts landed all over the table. I know about the gears but the plastic parts on the trigger assembly came off as well as the trigger assembly. Can i get a little help here? or at least can you point me in the right direction? thanks

[pappyjump]

if you havent used mechbox.com, i would highly reccommend it. (sorry for the spelling.) Take a look over there, other than that, im not an expert on airsmithing myself.

[Catch22]

http://actualairsoft.com/wp/?p=46

[thefiestysoldier]

pappen: I have been on mechbox.com and i do agree that they have lots of useful resources however they do not have what i need.

Catch: I was looking for a tutorial that examines the trigger and that area, preferably with a v3 box


thanks anyways.

EDIT:


after some more research i have gotten this far:


http://picasaweb.google.com/lh/photo/mvAPm9r58oh7iZZx27wiDA?feat=directlink

but i still am unsure about these pieces:




http://picasaweb.google.com/lh/photo/-lfoSLfL2rNLk8f66aog4w?feat=directlink


EDIT: now Im down to these 4 parts:

http://picasaweb.google.com/lh/photo/ECd_chuIpT_Shh388kAQaA?feat=directlink

EDIT: got the plastic piece on the bottom left out of the way. now for the last 3.

[Catch22]

It was from another thread

[thefiestysoldier]

im down to the last piece (the washer) so if anyone can help me there it would be greatly appreciated.

[Cap n pickles]

im down to the last piece (the washer) so if anyone can help me there it would be greatly appreciated.

The Washer?

Could you be more specific? A picture? Link a website with the same piece?

[~Thunder~]

im down to the last piece (the washer) so if anyone can help me there it would be greatly appreciated.

The Washer?

Could you be more specific? A picture? Link a website with the same piece?

Washer=Shim...?
Just a guess.

Good luck fiesty!

[thefiestysoldier]

I was referring to the picture from my previous post:

http://picasaweb.google.com/lh/photo/EC ... directlink

These were the last few I could not get and the washer on the bottom-right is the final piece (definitely not a shim)

[thefiestysoldier]

**Sorry for Double**


Here is another pic (not sure if it will help):

http://picasaweb.google.com/lh/photo/KY ... directlink


As you can see it is offset...

Thanks for looking

[Cap n pickles]

**Sorry for Double**


Here is another pic (not sure if it will help):

http://picasaweb.google.com/lh/photo/KY ... directlink


As you can see it is offset...

Thanks for looking

It is suppose to do that, to keep pressure on what ever its in between to prevent it from slipping off.

My best advice is to get on you tube and look around, iv'e only been in a G36 a few times, so I'm no pro.

[slipstream]

That is a type of lock washer.

I don't know about the V3 gearbox, but on V2 gearboxes, I have commonly seen lock washers placed under the screws along the top of the gearbox, used to hold the two halves of the GB shell together. Example of said screws:

[thefiestysoldier]

nailed it! (http://www.airsoftforum.com/board/lofiv ... 43274.html)

It goes around the screw that is under the stock. Thanks for all of your help.