by Pounce » Sun Jul 01, 2012 7:02 pm
I have an AGM HK 416 Metal body which has so far, knock on wood, been a decent little gun. It was shooting 420 fps out of the box so the first thing I had to do was swap out the spring. Might need to consider that if you are adverse to gears, gubbins and searching on your hands and knees for small screws and springs that go flying. While I was in the gearbox, I performed all of the air sealing mods and have managed to get a chronograph reading of around 350 give or take five fps. Accuracy has been a bit of an issue recently though, albeit my fault seeing as I have a hard time refraining from tinkering around inside things (can't tell if ' that's what she said ' applies there). The stock accuracy wasn't to bad, maybe a 5 inch spread at 30 feet discounting fliers. But in the pursuit of perfection, I was a bit over zealous and buggered it up. Right now, I have the stock barrel, stock two piece hop chamber and a PDI W-Hold bucking in it. My issue at the moment is it seems to be over hopping with the dial all the way off..... Oh well, more fun for me at a later date, I expect. Either way, the gun wasn't a KWA or TM, but for the money, it spits BB's well enough.