Re-Vamping my ROF and Internals

[Switchback]

http://www.hobbyking.com/hobbyking/store/uh_viewItem.asp?idProduct=24205


Well, $9.84. Plus shipping that wasn't much at all.

Ha, good one

Also, OP? A Deans connection in your rifle will decrease electrical resistance, and help you out quite a bit in the long run.

[Tork]

Omg i forgot about that website... next check i'm switching to lipo:D

[Tork]

Can someone link me a quality Lipo charger that charges mini tamiya and nimh?

[Payback]

I have this one. It doesn't have a tamyna connector, but has alligator clips that can charge it. They are all deans or RC car type connectors. And it charges everything. I also believe that thunderkiss has these in stock at their store. They are more cost, but once you figure in shipping and time, they aren't that bad.

http://www.hobbyking.com/hobbyking/stor ... UINE_.html

This one will charge lipo only by the balance lead. I have it also, but don't use it.
http://www.hobbyking.com/hobbyking/stor ... arger.html

Or you can just search through the different ones on the list.
http://www.hobbyking.com/hobbyking/stor ... rgers.html

[Evil Zergling137]

20rof is easy. 11.1 lipo and reasonable everything else.

[Evil Zergling137]

http://www.hobbyking.com/hobbyking/store/uh_viewItem.asp?idProduct=24205


Well, $9.84. Plus shipping that wasn't much at all.

It just offered it to me for 9.53 plus shipping!

[Payback]

http://www.hobbyking.com/hobbyking/store/uh_viewItem.asp?idProduct=24205


Well, $9.84. Plus shipping that wasn't much at all.

It just offered it to me for 9.53 plus shipping!

Yeah, i spent an hour waiting for it to pop up the lower offer but it never did. Also, just tried the 11.1 on my 60 with a high speed motor and gears. ate the piston in about 2 seconds, broke a tooth off the spur gear. Damn $9 battery just cost me allot more.

[Evil Zergling137]

http://www.hobbyking.com/hobbyking/store/uh_viewItem.asp?idProduct=24205


Well, $9.84. Plus shipping that wasn't much at all.

It just offered it to me for 9.53 plus shipping!

Yeah, i spent an hour waiting for it to pop up the lower offer but it never did. Also, just tried the 11.1 on my 60 with a high speed motor and gears. ate the piston in about 2 seconds, broke a tooth off the spur gear. Damn $9 battery just cost me allot more.

Welcome to the club =P

[Beran]

Personally I've never been a big fan of high ROF setups. I prefer a nice leisurely 12-15rps (720-900rpm) because 3-5 BBs is generally all I need since I tend to build my guns around accuracy and range. It's easier on the gun, conserves ammo, allows for more power and better consistency and is more realistic. The highest rate of fire that you'll see on the vast majority of infantry level small arms in the real world (not counting burst mode on a few less common rifles) is typically in the 1200-1500rpm (20-25rps) range. 35rps is 2100rpm.

Also I think an AEG firing at that speed sounds retarded. Give me the clack-clack-clack of a stock gun over the frantic WHRRRRRRR of a high rps gun any day.

[Tork]

Hmmm.... I think i will look into a MOSFET system and how to increase my accuracy. Thanks guys AP4L!