G&G gr-15 blow back question

[TheShadow]

I have been having issues removing the clip that holds the upper part of the gearbox and cylinder and piston for the blowback in place. Any of the tech's out there know any tricks to loosen this stubborn clip with out doing any damage to the gearbox or the clip? I have already tried putting a screwdriver in the notch and hitting it with a hammer to no effect I just started damaging the clip doing so.

[darkaces07]

Mine was stubborn I had to bang on it with a mallet and a screw driver. You could tighten the mechbox screws and see if it will come off

[Toan]

just get a thin and small flat head and place it on the lip of the bracket and smack it off with a mallet. might take a few hits.

[TheShadow]

already tryed that all that has happened is I have damaged the clip and put some nice marks in the gear box.

[darkaces07]

Where do you live. I can take a look at it if your in the portland metro area