A&K M60 Upgrades?

[DesertWArrior]

Hello Guys I recently purchased a MK43 from Evike and now I have $200 to blow on internals. I have questions, What should I buy? And if you say "A new piston head" please let me know what brand and make (such as V.3) or whatever. This would really help me!!!

[Payback]

A new cylinder head and nozzle.











As for parts, make models and stuff. There are so stinking many of them out there you really have to decide what your budget is, and more specifically where your going to buy them from. As each retailer online doesn't sell the same stuff, or more so they don't call them the same, they rebrand allot of stuff.

On my two 60's i've usually just gone to the local stores and said i need a new cylinder head, and they put one on the table, usually is a modify or something.

Ver.3 cylinder head, and it is an A&K masada brass nozzle you may need to order the nozzle from China on it's own. You can't just put on the nozzle without a new cylinder head for some reason. Well, there is a reason.


The spring guide is a Ver. 3 also, but you will have to file the tabs to fit right, takes about 5 seconds per tab.

Disconnect the mosfet also, it will eventually fail anyways. Put in a new bucking also.

[Toonvater]

dual sector gears

[Switchback]

Be sure to hold on to about $60 so you can have Jesse at AONW install all these gorgeous upgrades for you.
Tightbore barrel and non-orange flash hider, deans connectors and a high-capacity 7.2 volt Li-Po (if you have a Li-Po charger, if not, then use a high capacity 9.6). SHS or Systema/Guarder gear set. Some sort of high-performance piston to match your gears. And new bushings IF you have nylon/plastic ones in your A&K.