this is what I need. one of the stock extending "arms" (not sure if that is the correct term, but I think i clearly states what I am talking about.) on my MP7 broke. it broke due to something I was trying to attempt, but didnt quite succeed at.
the picture below shows the MP7 with the stock fully extended out. now the piece I need 'fabricated' is that metal rod type arm that extends from the reciever of the MP7 to the butt-plate. If you are unfamilar with the MP7, this is the exact same type used on MP5's and similar H&K weapons. Just the one for the MP7 is smaller in size then that of the MP5's or I would have tried to make it out of an MP5 'stock arm
now i have half of the original 'arm' still, the other broken half has since dissapeared. But I also still have the other sides fully intact arm which can be used as a template. All I really need is a piece of metal cut to the right length, and thickness. all the more detailed cuts in the stock arm i able to do on my own. I am sure most metal fab shops would have a piece of scrap metal around that would fit the need of what I am looking for. the rough deminsions of the stock arm are:
about 1ft (12inches) in total length x 11mm hieght x 6mm thick
if anyone know where i can get one of these made for me, please let me know who and where. it would be greatly apprecieated.
thank you,
Tommy
