How to use a PEQ box with this type of front wiring?

[GacktC]

Hello,
As you can see, the black wire is shorter than the red one. So how do I able to have this setup wire to the PEQ battery case on the RAS unit?

Thank you.

[CommieHunter]

You are going to need to extend your wiring. You'll have to solder on a new section of wire on the black, and possibly on the red as well. Put heat-shrink over the joint to keep it clean.

[Aeacus]

To add to Commie's post, I would suggest adding heat-shrink over both the red and black wires. It's a lot less noticeable with the lower profile, and will protect the wiring just that much more.

[GacktC]

Thank you gentlemen for the help!
So I need 12 or 14 gauge wire to do the extension? The gearbox is made by dboys, and the wire is extremely thin & I broke the motor tab already (fixed by CA shrink flex afterward).