front end conversion m4

[jake_smith1022]

I have a 2gx km4. Its outer barrel holds a 363 mm inner barrel perfectly. But i want to convert the outer barrel to hold the cqb type length so i can put a mock silencer on it.

So basicly i want a cqb outer barrel lengt h with out the front sight post. Then a free float ris hand guard. Followed by a mock silencer to gain back the length i lost due to the cqb outer barrel.

Question. Is the kwa delta ring a prepritory design? And can some one give me a link to buy desired front end?

Ps. I already own a madbul gem tech mock silencer a ris hand gaurd. Just need a outer barrel.
thanks

[CommieHunter]

I'd try this one. It gets you the standard CQB barrel, but you can convert it back to 14.5 if you want.

http://www.airsoftoutletnw.com/airsoft- ... -r-to-m4a1

[Alien_Hunter]

I will second CommieHunter's idea assuming the front ends are compatible. You should email AONW. Most retailers are more than happy to give you an answer.

[ClownBaby]

LOL. Uh, think he just did.

[McNair]

I'd try this one. It gets you the standard CQB barrel, but you can convert it back to 14.5 if you want.

http://www.airsoftoutletnw.com/airsoft- ... -r-to-m4a1

This is what I've used to swap between a Mk18 Mod 0 and a regular 14.5 M4.

[Alien_Hunter]

I'd try this one. It gets you the standard CQB barrel, but you can convert it back to 14.5 if you want.

http://www.airsoftoutletnw.com/airsoft- ... -r-to-m4a1

This is what I've used to swap between a Mk18 Mod 0 and a regular 14.5 M4.

On a side note, some CQB M4's with convertible barrels won't allow you to attach flash hiders and silencers because of the bayonet lug on the front sight. Just check before you buy.

[McNair]

Run a 10.5 instead of a 10.3