KWA KM4 SR10 Battery

[r416alex]

Hello I was wondering if there was any stock that could fit on the KWA Full Metal KM4 SR10 that could hold a Tenergy High Output 10.8V 5000mAh Ni-MH Large Type Battery. I already got the gun from another sight.

Battery: http://www.evike.com/products/29059
Gun: http://www.evike.com/products/31648

[Riddick]

Keep the collapsible stock and run 11.1 lipos

[Jewish Ninja]

A full stock might fit it, but it'd be a tight fit. I couldn't squeeze a similar size in my G&P M16 full stock... Speaking from experience, those batteries are not worth the price point.

Lipos in the buffer tube would be a much better option. Smaller, cheaper, steady discharge, less power lost over time, the list goes on. (Yes, Lipos are safe for your gun) You will need a lipo charger, but you can get 2 lipos and a charger for the price of that battery.

[McNair]

I will third the lipo suggestion. Personally I run 7.4s.

[Ironmonkie]

I actually run the 10.8 volt 5000 mah Tenergy, on a P90! Obviously it doesn't fit in the stock, I run it in a separate battery bag that I attached to my tac vest. It barely fits in the bag, had to use duct tape to keep it in there. I also extended the wire harness so I can still move the gun from one shoulder to the other.

[CommieHunter]

This battery is specifically made to fit the KWA crane stocks, and provide the most power that KWA recommends for their rifles (24 amps)

http://www.airsoftoutletnw.com/11-1v-12 ... ni-battery

[Alien_Hunter]

Nice, Commie Hunter.