Nark wrote:This is gonna sound dickish but whatever I'll be that guy...
ogrejager wrote:if your other mags work, don't sand the magwell--sand the new mags. I had to do that with a pack of mids that I'd bought at one point.
CarlitoCafe wrote:Mod the mag not the gun! mags are cheaper than a new lower
Nark wrote:This is gonna sound dickish but whatever I'll be that guy...
Nark wrote:I had the opposite problem with my M4. Mags were falling out at the slightest bump. Try sanding down the interior of the magazine well. Can you feel if there's any movement towards the top of where the mag would be when the mag is inserted? It could be that the magazine well is really tight but further up it's fine. Hope you figure out a solution quickly.renotheturk02 wrote:Wouldn't the negative velcro make a tighter fit? It seems the body of these mids are too wide, but I don't have any calipers to check. I'm not sure if sanding the mags would work because I think it'd take off too much materia in the process.
Nark wrote:This is gonna sound dickish but whatever I'll be that guy...
Users browsing this forum: No registered users and 7 guests