Bolt and spring help
5 posts
• Page 1 of 1
Bolt and spring help
by Osprey » Mon Aug 08, 2011 11:41 am
Ok I can't figure out to take out the spring out of the bolt to replace it. I'm getting to the point to buy a hole new upper recerver from TOKYO MARUI. The Gun Is AGM VSR10.
A man can be destroyed but not defeated.
- Ernest Hemingway
- Ernest Hemingway
-
Osprey - Ranger
- Team: N/A
- Posts: 669
- Age: 32
- Joined: Sun Jan 16, 2011 2:25 pm
- Location: Molalla, Oregon
by quigly » Mon Aug 08, 2011 11:43 am
You will have to buy a custom one from over seas. Any that are available state side have been out of stock for a long while. You may have better luck if you go with a bore up cylinder and receiver. I will try to find a link for the custom one.
My father once told me, "Some times all you have is a bullet and a prayer, don't miss."
-
quigly - Specops
- Team: N/A
- Posts: 1230
- Age: 30
- Joined: Sat May 23, 2009 7:35 pm
- Location: Lacey, wa
by Jester316 » Mon Aug 08, 2011 11:47 am
The cylinder head may be pinned on. Look just behind where it attaches to the cylinder and see if there is a pin/set screw looking thing. If not, then you need to unscrew the cylinder head.
FIRE CLEANSES ALL!
-
Jester316 - 1337
- Team: SpecDet1
- Posts: 5858
- Age: 36
- Images: 7
- Joined: Tue Oct 16, 2007 10:26 am
- Location: Beaverton
by quigly » Mon Aug 08, 2011 11:55 am
Oh shit. I just reread the post. If there is a pin, you will probably have to use a small drill bit and drill VERY shallow into it to remove the pin. If it is a little screw, just take it out.
My father once told me, "Some times all you have is a bullet and a prayer, don't miss."
-
quigly - Specops
- Team: N/A
- Posts: 1230
- Age: 30
- Joined: Sat May 23, 2009 7:35 pm
- Location: Lacey, wa
5 posts
• Page 1 of 1
Return to Bolt-Action & Snipers
Who is online
Users browsing this forum: No registered users and 7 guests
