Plates for Condor MOPC

[Goliath17]

I have a condor MOPC and I'm trying to find replica plates for it, but I can't find any that would work. If you know of any please help, thanks

[McNair]

Generally SAPI replicas should work?
Are they too big? Cut them.
Also, you can always get cutting boards from IKEA for like $1. You may have to just cut and sand the top part to make the curve.
Very sturdy, cheaper than foam, and has a little weight.

[Jewish Ninja]

AONW sells medium dummy plates if you want curved plates over the flatness of a cutting board.

[McNair]

AONW sells medium dummy plates if you want curved plates over the flatness of a cutting board.

I was thinking sometime of trying to heat some up in an oven or soemthing, where they're a little pliable, and shape them.

[Jewish Ninja]

It should work as long as you have something to form it on.

I haven't tried the cutting board route since my chest shape doesn't work well with a flat surface being pressed into it, and they aren't thick enough to look like plates. Though gluing a couple together might work...

[The Grand Baboon]

I found some leftover Plexiglass in the woodshop and cut two pieces into the dimensions of SAPI plates. I then used a blowtorch to custom mold them to my beautiful body. They're rigid, light, and give my Condor MOPC the much needed SAPI Viagra.

You could actually use an oven at ~200 F to do the same, but you'd need some heavy leather work gloves. Every hardware store in the country should have Plexiglass, I'd go to ACE personally.