I am trying to make a trishot shotgun out of an old spring singleshot gun.
I am only trying to see if is possible to do this.
This is only beta testing, so I am not concerned about FPS, accuracy, or consistency (or if its a good idea). I just want thoughts on how I could make it double or rather triple feed to fill the classification of tri-shot.
The hop up is just a short pipe around the Barrel, so I can make a replacement one on my lathe.
Also I have like 4 spare barrels, and a half dozen buckings so I am pretty much free to do anything to the hop up assembly.
I have the moved the slot of the nub forward, so that all three bbs stay in the barrel, and so that the nub does not block the pushing forward of the other two bbs. However, I feel that I must keep the bucking in the same place to keep a good air seal.
The only way I can think of is, that I could shim it in such a way to promote double feeding (its pretty loose).
Any thoughts?