KWA KP45 Tatical

[k3gn3123512]

I was playing around with my gun today and when i put the slide back i was touching the barrel and I felt it was wobbly. Is that normal?

[Jester316]

Inner barrel or outer barrel?

All of my GBB's the outer barrel moves around a little bit. It's the nature of the design. The inner barrel should not move.

[k3gn3123512]

Inner barrel or outer barrel?

All of my GBB's the outer barrel moves around a little bit. It's the nature of the design. The inner barrel should not move.

I think it is the outerbarrel. The part that is exposed when you move the slide back.

[shakespeare]

Yeah, that's the outer barrel. I'd say most to almost all GBB's are going to have a little wobble, because if too tight, it would grind against the slide pretty badly.

[CommieHunter]

It supposed to be loose when you have the slide back. It only locks when you have the slide fully in battery.

[Atallwhiteboy]

its like that on mine. do you have the problem when you put a new mag in and rack the gun it just starts firing in full auto?

[k3gn3123512]

its like that on mine. do you have the problem when you put a new mag in and rack the gun it just starts firing in full auto?

Nope.

[HKspecter-A2]

Is that normal?

yes.

[John_234]

its like that on mine. do you have the problem when you put a new mag in and rack the gun it just starts firing in full auto?

The hammer sear isn't functioning properly. Take it to a competent tech.

[k3gn3123512]

its like that on mine. do you have the problem when you put a new mag in and rack the gun it just starts firing in full auto?

The hammer sear isn't functioning properly. Take it to a competent tech.

A full auto USP. kinda makes me smile.

I've been currently trying to remove the orange tip from the gun, Nailpolish remover has done a real good job except the ridges, does anyone have a tip on how to get into the ridges?

[John_234]

Nailpolish remover worked for you? As far as I've seen the epoxied orange tips on KWA guns are hella resilient to solvents. Anything that removes the tip also takes the base paint layer...

[k3gn3123512]

Nailpolish remover worked for you? As far as I've seen the epoxied orange tips on KWA guns are hella resilient to solvents. Anything that removes the tip also takes the base paint layer...

Yes i managed to remove a good part of it with one hell of a scrubbing with Nailpolish remover. And actually the Tip is black now. exept for the ridges.

[GacktC]

Try Q-tip with modeling thinner.

[dr.feelgood]

I ended up painting my KWA, it was the only way.

[k3gn3123512]

Ok its now shooting in Full auto after my friend field stripped it to death.