List of Guns that shoot 1000 rpm+ stock

[KarnageAirsoftNW]

can you give me suggestions on guns that shoot 1000 rounds per minute without any ad-ons.

[Toonvater]

kwa mac 11 or m11a1.
and its gas bllowback

[glockmeister]

kwa glock 18, 23, and fully auto 26's

[Solid]

kwa mac 11 or m11a1.
and its gas bllowback

KWA Mac 11 is a beast, go for it. My gen 1 just started dying on me after 5.5 years of heavy use.

[Dinotacular]

G&P M4A1 (really any G&P gun with the updated gearbox) with a 9.6v battery or higher.

[slipstream]

kwa mac 11 or m11a1.
and its gas bllowback

KWA Mac 11 is a beast, go for it. My gen 1 just started dying on me after 5.5 years of heavy use.

Be ready to do lots of maintenance on it though. Mine gets very tempermental unless I regularly clean the barrel and lube the bolt.

Also the hop up dial is in line with the inner barrel, so sometimes changing the hop-up setting will cause the inner barrel to rotate a few degrees, and this will make the bb's start curving off to one side.

But when it is working right, it is absolutely wonderful.

[G36 FTW]

The Well GBB mp5k has around 1300 if I'm not mistaken, and that means the Maruzen gbb mp5k (the thing Well cloned) probably does as well.

[Lunchbox]

Well did not clone TM, they cloned the Maruzen

[G36 FTW]

Well did not clone TM, they cloned the Maruzen

Good catch, my bad.

[KarnageAirsoftNW]

ehh i dont really want a gas any electric like g&g m4s or something like that or should i just buy a separate motor

[Patrick750]

if you want a aeg you need to buy a better motor and a lipo. why would you need 1000rpm anyways? just to waste ammo? get a good battery and use semi

[G36 FTW]

If you really need over 1000rps (leik meh) then all you need is a better motor and a 9.6v battery.


I would suggest a motor from G&P.

High Torque (will still get over 20 rps and will also result with improved trigger reponce on Semi and Full auto):
http://www.airsoftgi.com/product_info.p ... ts_id=2810

High Speed (will give you better rof than the high torque, but not the better trigger sensitivity):
http://www.airsoftgi.com/product_info.p ... ts_id=3954

[Toonvater]

I got a g&g that shoots I think around 1000 rof. If you want a awsome g&g gpo to airsoft gi and get one of there g4 modles cauz there all reliable. And if your getting a g4 get the hard ver, its has a longer barrel but its not so long that you can't hold it.

[Prophet]

All G&Gs shoot over 1000 and most CAs do, too (not the blowback CAs), but a G&G standard'll give you about 1200 rpm (from what I've heard), and I'm getting one, plus, they are $15 cheaper than the G&P with roughly the same performance

[ogrejager]

I got a g&g that shoots I think around 1000 rof. If you want a awsome g&g gpo to airsoft gi and get one of there g4 modles cauz there all reliable. And if your getting a g4 get the hard ver, its has a longer barrel but its not so long that you can't hold it.

What did you say?