wiring for my peq box

[phantom -VSR-]

So pretty soon here i'll be getting a Socom gear Daniel Defense 9" ris. Since I will not be wiring my gun to the back how would I get the wiring to work to have the least amount of it showing going to the peq box? And this particular rail is not a 2 piece so please keep that in mind. Thanks.

[Duniway]

Clip the Tamiya connector off, put wires through RIS, re-wire charger, gun and battery(s) to deans.

[phantom -VSR-]

Any other ways?

[Jester316]

Here is the other way:

Clip the Tamiya connector off, put wires through RIS, re-wire gun.

Either way, you'll have to cut the plug off because it isn't a 2 piece rail. Why not wire it to the back? You can put a spare mag pouch on the buttstock, and keep the battery in there. Or if it's an M16 stock, the battery will easily fit inside.

[phantom -VSR-]

How do I put the connector back on?

[Jester316]

With solder...

http://www.aaroncake.net/electronics/solder.htm

[RiotingCows]

Is it this rail?
http://www.airsoftgi.com/product_info.p ... ts_id=5768
I find that a lot of rails have wholes big enough to stick a small tamiya through and sometimes deans.
Is looks like you might be able to squeeze it through.

[phantom -VSR-]

Yeah that's the one.

[RiotingCows]

Yeah that's the one.

Just wait till you get the rail and see if you can fit your connector through the wholes. If you small type it should go right through, Deans might but doubtful, and large type you'll have to pop off the connector.

[phantom -VSR-]

Yeah I have a mini type connector so we'll see what happens. Thanks for the help.